0

Your Cart is Empty

Shop For
  • Help & Information
  • Gallery
  • CREATIVES

  • Portfolio book inside portfolio box

    Portfolio books and boxes used by professional Photographers, Designers and Architects

  • BUSINESS

  • leather tender presentation proposal box and binder

    Presentation binders and boxes made by us and used by Companies and Corporations

  • HOSPITALITY

  • Bespoke leather guest book

    Products used in Restaurants, Boutique Hotels and on Super Yachts

  • VEHICLES

  • thumbnail custom vehicle history binder

    Bespoke binders and boxes for classic cars and motorcycles

  • February 09, 2018 2 min read

    Answers to your questions on print sizes.

    All artists want to present their work to the highest of standards and therefore we have put together this guide on the best practice to placing your prints into your portfolio book.

    Always remember, We build your portfolio around the size of the media you are placing inside it. 
    If you are placing an A3 landscape page directly into your portfolio, we will base the size of the portfolio cover on a 297mm x 420mm sheet. If you are using Hinge Strips on your prints, then we will add an extra 25mm to the width of the portfolio cover and like wise, if you are using Page Protectors, the cover will be wider and longer again. As a warning (I know a bit early to be issuing warnings, but) if you were to state on your order that your portfolio will not have page protectors and you later decide to use page protectors, you'll find that the portfolio cover is a little too small for your prints.

    Margin (Gutter) Size

    For screw post portfolios, When laying out your images on the page, remember to include a 2.0 - 2.2cm left hand margin for your holes and cover, (i.e. Don't print to across the whole page!) 

    If you follow the steps below, you'll be good to go!

    1. First you begin by adding in a 2 cm margin onto your print for your full piece to be shown once placed inside the portfolio. (we suggest 2.2 cm margin to ensure your work in fully on show)

    2 cm gap for the margin on print

    2. Once your print has been printed out, you can hole punch into the centre of the 2 cm margin.

    hole punching the prints

    3. Measure 2.2cm's from the left hand edge of the page - If you can, use dividers as they will pre-score a folding line in your page.

    scoring the margin for the print

    4. Place a ruler along the edge of your scored mark and then run a bone folder along the edge of the ruler into the pre scored mark. This creates a deeper crease (scoring). Don't over do it! You are not trying to cut the page, just creating a neat crease
    Once you have done that, fold the edge of the page to make it neat.

    scoring and folding the print

    5. The next step is to open your portfolio. To open a screw post portfolio, you must twist off the screws, taking off the front cover.

    unscrewing the screw post portfolio

    6. You can now place your prints into the portfolio.

     
    placing print in the portfolio

    You should now be able to see your artwork in whole.

    Another simple step to keeping your portfolio at the highest standard is by adding hinge strips to all your prints. Hinge strips will keep your work at its finest state for longer, and are incredibly simple to add. To view our guide on using hinge strips click here.  

    As you might have noticed, the pages we've used were printed by M Print Portfolio Printers in London - They're one of our partners and specialise in very high end portfolio printing. You can find them here

    We also have a handy guide about buying the right photography portfolio which can be found here

    If you have any questions, please contact us at info@hartnackandco.com